A well-made, well-fitted shoulder holster the whole thing
exceedingly well for heavy revolvers. In fact, in my estimation, they work healthier
than hip-mounted holsters since they spread the weight of the gun over a greater
area of the physique. Take for example my favorite revolver, the four-inch
Smith & Wesson Model 657 N-frame .41 Magnum pistol. Carrying it on the hip necessitates
a thick and wide midriff belt. Even afterward hours of use, it’s not uncommon
to suffer nervousness in the small of the back or side. I have originated that
a respectable, well-adjusted shoulder holster makes it easy to carry this heavy
handgun for days on end with little effort or apprehension.
If you are one who escalates long-barreled pistols, the
shoulder holster may be your only choice for concealed carry. I’ve concealed
and carried N-frame Smith & Wesson pistols with tubs if 8-3/8 inches.
Granted, I had to wear a goose-down vest as a covering clothing (mainly to
cover the “toe” of the holster, as it would twig out the bottom of everything
shorter), but seeing the extremely low ambient air infection, everyone else was
exhausting similar clothing. The gun was never noticed. Even with barrel measurements
of six shuffles or so, a shoulder holster is around the only practical income
of concealing the gun.
When I took a Decision-making Defense course through the Tony
Scotti University of High Performance Driving, somebody asked what was the best
way to carry a pistol while driving. The driving teacher said simply, A
shoulder holster. Our shooting instructor didn’t like that answer, but it’s
true. A shoulder holster is not surrounded by the seatbelt and it permits the
defensive handgun to be obtainable in a variety of circumstances. Only the
counter-alternative ankle holster is as freely available while seated in a
vehicle, but it is limited to much smaller pistols.
As a agriculturalist, I’ve originate that shoulder holsters
are actually the only response if I want to be armed with a pistol. Like the
executive defense specialist, I’m complicated with motorized vehicles, but additional
to that is the detail I also have to repeatedly work on these busses.
If you have to crawl under a piece of machinery to tighten
bolts, check transmission fluid levels, or reset rock trap doors, the hip
mounted holster acts like a gravel scoop. If the gun is heavy and hip-mounted
then the whole rig will pull your pants low. And after crawling under
something, you may get stuff in places that makes your wife wonder, “What in
the world has he been doing?” when she does the laundry.
With a modest covering clothing like a zippered-front hooded
sweat shirt, I can use the shoulder holster when I work about machinery without
infectious the butt of the gun on pedals, electrical lines, hydraulic lines, or
even manacles of various countryside.
The covering garment and the shoulder holster act similar the
ultimate flap holster in tremendously dusty or muddy environments, as I’ve erudite
many, many periods over the years. The mixture of the two retains the gun far domestic
than even the best flap holster, and you do it all to no one’s information.
